MIMAKI UJF-3042 MkII - Solving the Ink Overflow Problem

Chapter 4 Maintenance
4-17
1
2
2
4
5
6
Replacing the mist filter
1
Press the
(MENU)
in LOCAL.
2
Press to select “ MAINTENANCE ”,
and press the key.
• MAINTENANCE MENU will be displayed.
3
Press the key.
• “STATION” will be selected.
4
Press the key.
• “CARRIGE OUT” will be selected and the carriage
will move.
5
Open the left maintenance cover.
6
Remove the mist filter.
• Mist filters are located in two places.
• To remove the mist filter, pull the knob to the front
while pushing the hook in the direction indicated
by the arrow.
7
Replace with a new filter (SPC-0819).
8
Insert the mist filter.
9
Close the maintenance cover, and press
the key.
• After its initial operation, the machine returns to
LOCAL.
If a Waste Ink Tank Confirmation
Message Appears
Ink used in head cleaning, etc. is stored in the waste ink
tank on the lower right side of the machine.This machine
counts the accumulated amount of discharged ink. When
that reaches a specified amount, the machine displays a
confirmation message.(When this message is displayed,
consider the replacement of the waste ink tank.)
Confirmation Message in LOCAL
1
The warning message “Check waste ink”
is displayed.
2
Empty the waste ink tank according to
“Replace the waste ink tank with
another”( P.4-18).
• When it is different from the actual amount, press
[][] and correct.
Hook
Knob
HookKnob
• The message is displayed when it reaches 80%
(1.3L ) of the 1.6L tank.