3-19
Chapter 3 Machine setting
3
2
2
2
Setting a KEY BUZZER
You can turn off the buzzer sound when pressing the key.
1
Press the
(MENU)
(>>)
key in LOCAL.
• MACHINE SETUP MENU will be displayed.
2
Press to select “KEY BUZZER” ,
and press the key.
3
Press to select a set value, and
press the key.
• Set value : ON/ OFF
4
Press the key several times to
end the setting.
Set the network
You can also perform network setting with “Network
Configurator”, the tool to perform network setting of
Mimaki’s product. To download the Network Configurator,
check " Driver / Utility" on the download page at Mimaki
Engineering (http://mimaki.commimaki.com/download/).
1
Press the
(MENU)
(>>)
key in LOCAL.
• MACHINE SETUP MENU will be displayed.
2
Press to select “NETWORK” ,
and press the key.
3
Press to select “CHECK IP
ADDRESS” , and press the key.
• The IP address currently used by this machine is
displayed.
• When you have finished the check, press the
[ENTER] key.
4
Press to select “CHECK MAC
ADDRESS” , and press the key.
• The MAC address currently used by this machine
is displayed.
• When you have finished the check, press the
[ENTER] key.
5
Press to select “DHCP” , and
press the key.
6
Press to select a set value, and
press the key.
• Set value : ON/ OFF
• When it is ON, the IP address given by the DHCP
server is used.
7
Press to select “AutoIP”, and
press the key.
8
Press to select a set value, and
press the key.
• Set value : ON/ OFF
• When it is ON, the IP address is determined by
the AutoIP protocol. However, DHCP is ON,
DHCP has priority.
9
Press to select “IP ADDRESS” ,
and press the key.
• When the key buzzer is set to "OFF", the buzzer
sound for errors, warnings, operation completion,
etc. cannot be shut off.
• After connecting with the network, it takes time until
the IP address is determined. If the IP address has
not been determined, “0.0.0.0” is displayed.
To Next Page
Loading...
