3-3
Chapter 3 Setup
3
2
2
2
Setting the Media Thickness
If the media thickness is changed, Table Height is also
changed.
1
Press the
(MENU)
key in LOCAL.
• HEAD HEUGHT MENU will be displayed.
2
Press to select “MEDIA
THICKNESS” , and press the key.
3
Press to set the media thickness,
and press the key.
Set value : 0.0 to 53mm
4
Press the key several times to
end the setting.
Setting the HEAD GAP
If the head gap is changed, Table Height is also changed.
1
Press the
(MENU)
key in LOCAL.
• HEAD HEiGHT MENU will be displayed.
2
Press to select “HEAD GAP”
key.
3
Press to set the table spacer, and
press the key.
• Setting value：1.5 to 5.0 mm
4
Press the key several times to
end the setting.
Gap check
Select operation when obstacles are detected
during printing.
1
Press the
(MENU)
key in LOCAL.
• HEAD HEIGHT MENU will be displayed.
2
Press to select “GAP CHECK” ,
and press the key.
3
Press to select the mode, and
press the key.
• Set value: ON, OFF
• When ON is selected:
You can select the behavior.
Select one from the three types below:
AUTO ：Before drawing, the work height is
checked with the specified table height
(media thickness).Before and during
drawing, if the work sensor is shielded,
the table is lowered until it is
unshielded to change the table
height.If the work sensor is shielded
when the table is lowered to the
bottom, a message of [WORK High]
appears and the operation stops.
MANUAL ：You can manually set the height of the
work.(Gap Set)
It does not check the work height
before and during printing.
STOP ：Before drawing, the work height is
checked with the specified table height
(media thickness), and if the work
sensor is shielded, a message of
[WORK High] appears and the
operation stops.
• When OFF is selected:
Print without a check of the work height.
4
Press the key several times to
end the setting.
Table spacer
Set the length of the table spacer you are using.
1
Press the
(MENU)
key in LOCAL.
• HEAD HEIGHT MENU will be displayed.
2
Press to select “Table spacer” ,
and press the key.
3
Press to select the table spacer,
and press the key.
• Set value: 0 mm, 50 mm, 100 mm
4
Press the key several times to
end the setting.
• Please check the work height visually before
printing since there is a possibility to hit the work
and the head.
• Please check the work height visually before
printing since there is a possibility to hit the work
and the head.
• The gap check function is not a function to avoid the
head hit completely by detecting obstacles. It is also
possible to lower the detection accuracy by the
shape and material of the work.Even when the GAP
CHECK is “ON”, be sure to check the work height
visually before drawing.
To Next Page
Loading...
