MIMAKI UJF-3042 MkII - MAINTENANCE Menus At-A-Glance

4-5
1
2
2
4
5
6
Chapter 4 Maintenance
MAINTENANCE MENUs at-a-glance
Item Set value Meaning
STATION
MAINTENANCE
For carrying out maintenance on the carriage and station periphery.
CARRIAGE OUT
(P.4-6)
Moves the carriage out, for carrying out cleaning of the cap periphery,
head, wipers, etc.
REPLACE
WasteInkTank
(P.4-9)
Resets or corrects the used count for the waste ink tank.
DISWAY WASH
(P.4-9)
Wash the ink discharge passage
Replace WIPER/
WIPER Absorber
(P.4-16)
Used when replacing the wiper and wiper absorber.
If the wiper is replaced, the number of times the wiper was used that is
managed in this device is reset.
NOZZLE WASH
(P.4-8)
1 to 99 min
Soaks the nozzle surfaces in maintenance cleaning fluid, for carrying
out recovery from nozzle clogging or bent.
CUSTODY WASH
(P.4-10)
1 to 99 min
Carried out when the machine is going to be out of use for an extended
period. Washes the nozzles and tubes beforehand, to keep the
machine in fine condition.
NOZZLE
RECOVERY
(P.4-13)
For using another nozzle for printing when any nozzle cannot be recovered.
PRINT Prints a pattern, to identify the nozzle that is clogged.
ENTRY Registers the faulty nozzle identified by “PRINT”.
RESET Resets a registered faulty nozzle.
UV LAMP
(P.4-14)
UV USED TIME
This displays the total time for which each of the UV lamps has been
illuminated.
Overflow
(P.4-14)
For discharging excessive ink in the sub tank to solve the ink overflow problem.
Automatic
Maintenance
(P.4-15)
For having the various maintenance functions executed automatically. Set the execution interval for each
maintenance function.
REFRESH OFF For setting the activation interval for refresh.
CLEANNING INTV 12h For setting the activation interval for the head cleaning.
Water FillUp
(P.4-19)
For supplying hot water.
SUB TANK
MAINTENANCE
(P.4-11)
Perform when a large amount missing nozzle is not restored.