3-18
Chapter 3 Machine setting
Setting a AUTO Power-off
When no operation has been performed for the set time,
the power supply is automatically turned “OFF”.
1
Press the
(MENU)
in LOCAL.
2
Press to select “Machine Setup”,
and press the key.
3
Press to select “AUTO POWER
OFF”, and press the key.
4
Press to select a set value, and
press the key.
• Set Value : OFF / 10 to 600min
5
Press the key several times to
end the setting.
Setting Time
You can set time of your country (time difference).
1
Press the
(MENU)
(>>)
key in LOCAL.
• MACHINE SETUP MENU will be displayed.
2
Press to select “TIME” , and
press the key.
3
Press to enter time, and
press the key.
• Hour/Minute/Second/Time selecting:
by the [][] keys.
• Hour/Minute/Second/Time inputting:
by the [][] keys.
4
Press the key several times to
end the setting.
Setting Unit (Temperature/ Length)
Units used by this machine are set.
1
Press the
(MENU)
(>>)
key in LOCAL.
• MACHINE SETUP MENU will be displayed.
2
Press to select a set value, and
press the key.
• Set value of length : mm / inch
3
Press the key several times to
end the setting.
• If the machine received data from the PC in the
auto-power-off status, the power supply is turned
ON, however, printing operation is not started
automatically.
• -20 hours to +4 hours can be set.
To Next Page
Loading...
