Chapter 1 Before Use
1-10
Instructions for using the table
When using jigs, set the width to A and the depth to
464mm or less.
If you exceed the dimensions above, the table cannot be
moved.
Connecting the cables
Connecting the USB2.0 interface
cable
Connect a computer to this machine with the USB2.0
interface cable.
Notes on USB 2.0 Interface
When two or more UJF-3042MkII/6042MkII
machines are connected to one personal computer
When two or more UJF-3042MkII/6042MkII machines
are connected to one personal computer, the personal
computer may not recognize all the UJF-3042MkII/
6042MkII machines normally.
Reconnect the unrecognized UJF-3042MkII/6042MkII
machine to another USB port, if available, and check
to see if it is recognized.If the UJF-3042MkII/6042MkII
machine is not recognized by the newly connected
USB port, use USB 2.0 repeater cables available on
the market.
464mm
364mm
464mm
• UJF-3042MkII
• UJF-6042MkII
674mm
• Prepare the USB2.0 interface cable. (USB2.0
interface cable is not supplied with this machine.)
• Your RIP is required to support USB2.0 interface.
• If USB2.0 interface is not installed in your
computer, ask a RIP maker near you or our branch
office.
• Your RIP must be compatible with USB 2.0.
To Next Page
Loading...
