Chapter 2 Basic Operation
2-10
Checking printing data that is being
received or has been received
When printing is interrupted or print data is received on
the local mode, the warning message "DATA REMAIN"
appears on the display.
At this time, if you press the [FUNC3] (REMOTE) to
migrate to the remote, printing is started or restarted.
When [! WORK High] is displayed
When warning message “! WORK High” is displayed on
the screen and the printing operation stops during
printing, restart printing with the procedures below:
1
Press the key.
• The screen returns to LOCAL.
2
Check the media setting status, and press
the (REMOTE).
• The machine restarts printing.
• If you do not wish to restart printing, refer to the
P.2-9 “Interruption of printing” and interrupt
printing.
If you open the cover during printing
If you open the cover during printing, the warning
message “Reset a switch” is displayed on the screen.
1
Close the cover and press the
key to suspend printing.
• Machine starts initialization.
• During printing, the sensor always monitors the
media height. When the gap check function
( P.3-3) is set to “OFF”, if the sensor detects
the media, the printing operation is interrupted
automatically, and “! WORK High” is displayed on
the screen.
• If the cover is opened while printing is not
performed, “Close the cover.” is shown on the
display. In this case, press the [ENTER] key
To Next Page
Loading...
