2-9
2
2
2
5
6
Chapter 2 Basic Operation
Printing an image from
source data
Starting the printing operation
1
Set the media. ( P.2-4)
• When you set the FAN MODE setting ( P.3-
12) to “MANUAL”, press [SEL] and [FUNC1]
(VACUUM) depending on the use and vacuum
the media.
2
Press the (REMOTE) in local.
• The machine goes in the remote mode and data
from the computer can be received.
• The table height (including the vacuum table and
the table spacer) is displayed.
3
Transmit data to be drawn from the
computer.
• Printing conditions are displayed.
• As for the data transmission method, see the
instruction manual of the output software.
4
Start printing.
• The printing origin is not changed after completion
of the printing.
5
Taking out the media after completion of
printing.
(1) When you made vacuum ON, Press the
[FUNC1] (VACUUM) to turn the adsorption
OFF.
(Only for UJF-6042MkII)
(2) Remove the media.
Interruption of printing
To interrupt printing, stop the printing operation and erase
the received data from the machine.
1
Press (LOCAL) while printing.
• Printing operation stops.
• When data is transmitted from the computer, the
computer stops transmission of data.
2
Press the key onece.
• "DATA CLEAR" appears on the lower line of the
display.
3
Press (DATACLEAR).
4
Press the key.
• Received data is erased and the machine returns
to the local mode. The tabel moves to the
evacuation position.
• If the temperature of the head has not reached the
predetermined value, a message is displayed.
Printing is not allowed in such cases. When the
display is disappeared, printing can be started.
• Data transmission is allowed even if errors are
displayed. Printing is started after the display is
disappeared.
The length of media printed
PRE PRINT POST
REMOTE
00
mm
00
mm
40°/50°
600x900 VD
12p / Uni / Hi / 151.5mm
Resolution
600 /900 /1200 DPI
Number of passes
Scan direction
Uni : Unidirectional
Scanning speed
Nor: Normal speed
Hi : Double speed
Height of the current table
• When you use the vacuum function of
the vacuum table to draw, turn OFF the
vacuum when printing has been
completed.
• During printing, media may be heated by the LED
UV and raised, causing printing to be interrupted.
In this case, set new media and restart printing.
• To restart printing, press the [FUNC3]
(REMOTE).
To Next Page
Loading...
