MIMAKI UJF-3042 MkII - Cleaning the Mist Filter

Chapter 4 Maintenance
4-7
1
2
2
4
5
6
9
Clean the cap rubber.
• Wipe off the ink sticking to the cap rubber with a
cleaning swab dipped in maintenance solution for
maintenance.
• Wipe off so that maintenance solution for
maintenance will not remain.
10
Press the key after the cleaning.
11
Close the maintenance cover then press
the key.
• After its initial operation, the machine returns to
step1.
Cleaning the mist filter
1
Press the
(MENU)
in LOCAL.
2
Press to select “ MAINTENANCE ”,
and press the key.
• MAINTENANCE MENU will be displayed.
3
Press the key.
• “STATION” will be selected.
4
Press the key.
• “CARRIGE OUT” will be selected and the carriage
will move.
5
Open the left maintenance cover.
6
Remove the mist filter.
• Mist filters are located in two places.
• To remove the mist filter, pull the knob to the front
while pushing the hook in the direction indicated
by the arrow.
7
Clean the filter.
• Remove the filter, and remove the stain by holding
paper towel or the like.
• Wipe off any stain adhering to the filter case.
8
Set the mist filter at the original position.
9
Close the maintenance cover, and press
the key.
• After its initial operation, the machine returns to
LOCAL.
• Wipe off so that no ink or cleaning solution
remains on the rim of the cap rubber.If ink
remains, nozzle missing or mixed color may occur.
Cap rubber
• If the stain strongly attached to the filter, such as
the liquefaction of the ink attached to the filter,
please replace the filter (SPC-0819). ( P.4-17)
Hook
Knob
HookKnob