Chapter 1 Before Use
1-11
1
2
2
2
2
Notes on peripheral devices in USB high speed mode
When a peripheral device (USB memory or USB HDD) to
be operated in USB high speed mode is connected to the
same personal computer that a UJF-3042MkII/6042MkII
machine is connected to, the USB device may not be
recognized.
When UJF-3042MkII/6042MkII is connected to the
personal computer to which an external HDD is
connected via USB, the speed of data output to UJF-
3042MkII/6042MkII may drop.That can cause the
head unit to stop temporarily at the right or left end
during printing.
Removing USB memory
If a USB memory module is inserted in the personal
computer to which a UJF-3042MkII/6042MkII machine
is connected, click "Stop" in the "Safely Remove
Hardware" window by following the instructions given
there first and then remove the module.
Leaving a USB memory module inserted can cause
[ERROR 10 COMMAND ERROR].
Copy the data onto the hard disk before outputting it
for printing.
Connecting the LAN cable
When connecting LAN cable, be sure to follow the note
below:
Printing Via a Network
If printing via a network, you need to configure your
network with the following environment.
If you configure it with an inappropriate environment, it
could cause printing to stop.
• Use LAN cables that are category 6 or higher.
• Use a switching hub and PC that support 1000BASE-T.
If the PC or device connected to the printer is not
1000BASE-T, you cannot perform printing.
After connecting, check the following.
(1) Check the printer screen display.
• On the local screen or the media detection screen, press
the [Enter] key several times to display the information
screen.
(2) Check the green light of the LAN connector.
• After turning on the machine, the lamp for the LAN
connector will light up as follows.
Connecting the power cable
• Surely insert LAN cable until clicking noise
sounds.
• Do not plug in or unplug any cable during data
transferring.
• Set the PC sending the print data and the printer
to the same network.
• You cannot connect via a router.
Color Lit? Condition
Green
ON Connected with 1000BASE-T
OFF Connected without 1000BASE-T
Yellow
ON Link-up
Blinking Receiving data
OFF Link-down
• If the yellow light only lights up, or is blinking, the
status is not 1000Mbps. Check the specifications
of the PC, device, and cables.
• Use only the supplied power cable.
• Be sure to connect the power cable plug to the
grounded outlet, or it may cause fire or electric
shock.
• Take care not to damage, break or work upon the
power cable. Or if putting a heavy thing on,
heating, or pulling the power cable, the power
cable can break to cause fire or electric shocks.
If connecting directly to the printer
Switching hub
If connecting via a switching hub
To Next Page
Loading...
