3-26
Chapter 3 Confirming Machine Informationa
About NOZZLE CHECK MENU
Set operations concerning the nozzle missing detection function.
UJF-3042MkII is displayed only when the NCU option is installed.
INFORMATION MENU table
Function name Set value Default Meaning
Printing Check ( P.3-28) ON/OFF ON
Set this when you want to conduct nozzle check at the
beginning of online printing.
(ON)
Check
Interval
SET UP Job Job Conducts nozzle check for each file.
Interval 1 to 100 30 file Conducts nozzle check at each set number of files.
*1
*1. When the set length is reached during printing, nozzle check is conducted at the start of the next printing.
Action
CLEANING
OFF/ SOFT/
NORMAL/ HARD
SOFT Sets the type of cleaning performed during recovery work.
RETRY
COUNT
0 to 3 1 Repeats the retry operation for the set number of times.
NOZZLE RECOVERY
(P.3-28)
ON/OFF OFF Set this when you want to conduct automatic nozzle recovery.
Judgement Condition
(P.3-28)
1 to 100 1
Sets how many missing nozzles are detected for “Nozzle
Missing” judgment to be made according to each color.
(Maximum 10 per 1 nozzle line)
*2
*2. Depending on the print conditions, nozzle recovery is not applied in some cases.
MENU 2/3
〈〈
VACUUM
〉〉
MACHINE SETUP
>
>
>
NOZZLE CHECK
INFORMATION
LOCAL 10：22
0.0
mm
0.0
mm
53.0
mm
MENU
TEST PRINT /
CLEANING
REMOTE
Lc
Lm Y C M K W CL
2回
LOCAL 10：22
0.0
mm
0.0
mm
53.0
mm
MENU
TEST PRINT /
CLEANING
REMOTE
Lc Lm Y C M K W CL
NOZZLE CHECK
Printing Check
ON
OFF
>
Auto Nozzle Recovery
Judgment Condition
〈〈
VACUUM
〉〉
NOZZLE CHECK
Printing Check
ON
OFF
>
Auto Nozzle Recovery
Judgment Condition
〈〈
VACUUM
〉〉
NOZZLE CHECK
Printing Check
ON
OFF
>
Auto Nozzle Recovery
Judgment Condition
〈〈
VACUUM
〉〉
NOZZLE CHECK
Printing Check
ON
OFF
>
Auto Nozzle Recovery
Judgment Condition
〈〈
VACUUM
〉〉
NCU MENUs at-a-glance
: Press this to select NOZZLE CHECK MENU, or to switch to the previous screen.
: Press this to switch to the next screen.
: Use these to select a setting item.
: Press this to confirm a setting, etc..
To Next Page
Loading...
