x
For safe operation
1
2
2
2
2
2
UV light
• A little UV light spills around the LED UV unit.
UV light applied to your skin might cause
inflammation and/or skin cancer.
Even weak UV light causing no inflammation
may lead to chronic disorders by repeated
exposure. Avoid applying UV light to your skin
and eyes.
• Impairment of eyes caused by UV light may be
acute disorders, pain in eyes, tearing, chronic
disorders, cataract, etc.
When using this machine, protect your body
such as gloves, long-sleeve cloth, light-
resistant mask, attached light-resistant
glasses, etc.
Notes on LED UV
• When handling the glass on the bottom of the
LED UV unit, be sure to wear the gloves
attached and never touch them with bare
hands. Or the UV ink curing level may
significantly lower. If the glass becomes dirty,
wipe it with clean gauze moistened with
alcohol. (Do not use alcohol for cleaning the
exterior cover, or the paint will peel off.)
• The LED UV performance and service life are
significantly affected by the UV irradiation and
UV power supply units used. Never use those
UV devices other than those recommended by
Mimaki. We would take no responsibility for
any troubles caused through the use of a UV
devices not recommended by Mimaki.
Cleaning
• After using this machine long time, foreign
materials and dust may be gathered on the
conductive and insulating parts, causing
electric leakage. Periodically clean such parts.
• For cleaning, do not use compressed air
because it scatters foreign materials and dust,
which may cause malfunctions when put
inside the conductive parts. Be sure to use
vacuum cleaner to vacuum off foreign
materials and dust.
• Do not use the machine in a place where there
is a possibility of being wet, or electricity may
leak.
• Electrical leakage may lead to electrical shock
of personnel or fire.
• To prevent accidents, be sure to carry out
periodic inspections and replace periodic
replacement parts.
Periodic exchange parts
• There are some parts which must be
periodically replaced. Contract with
distributors or dealers for maintenance.
Adjusting the level
• Keep this machine horizontal.
CAUTION
Firing and smoking
• Touching hot parts such as the LED UV with
combustible materials may cause firing and/or
smoking.
Leaving combustible materials under the LED
UV unit for a couple of minutes may also
cause firing and/or smoking.
• After this machine is used long time, foreign
materials or dust gathered may cause
electrical leakage, or insulation deterioration
may cause firing and/or smoking. Periodically
clean this machine and replace the
deteriorated parts after the insulation
resistance.
• After this machine is used long time, screws or
others on the conductive parts may be
loosened, causing firing and/or smoking.
Periodically tighten the screws.
• If abnormalities such as a strange odor, a
smoking or a spark burn occurred, turn the
power off and call our office immediately.
CAUTION
To Next Page
Loading...
