Chapter 1 Before Use
1-14
(2) Tighten the specialized cap using the
tightening jig.
(3) Turn the bottle upside-down and check that
ink does not leak.
4
Set the ink bottle on the tank.
• Set the ink bottle while moving the lever on the
tank completely to the right.
5
Move the lever on the tank completely from
the right to the left side.
6
Insert the IC chip.
• Insert the IC chip with metal to upward. If you
insert the wrong side by accident, it causes faulty
or damage of the IC chip.
• Do not touch the metal part of the IC chip. It may
break the IC chip by static, or may cause read
error by stain or flaw.
• For the setting orders of the ink bottles, refer to
P. 6-4 .
• Tighten until the arrows on the tightening jig are
aligned.
• Do not tighten the dedicated cap too
• Do not leave an ink bottle with the specialized cap
attached in a location where it is exposed to light
for a long period of time. Doing so can result in the
ink in the bottle curing (hardening).
Align the with the
tightening jig.
Tightening jig
• Do not ever rotate the ink bottle at all after setting
it into the tank.
Doing so can result in ink leakage.
To Next Page
Loading...
