MIMAKI UJF-3042 MkII - Setting the network

3-21
Chapter 3 Machine setting
3
2
2
2
Set the event to send an event mail
1
Press the
(MENU) (>>)
key in LOCAL.
• MACHINE SETUP MENU will be displayed.
2
Press to select “EVENT MAIL” ,
and press the key.
3
Press to select “SELECT EVENT”
, and press the key.
4
Press to select the "ON" or
"OFF" of the event, then press the
key
.
• Select the ON / OFF of the event in the order
shown in the table below.
After the ON / OFF setting, please proceed to the
next event settings by pressing the [ENTER] key.
• Press the [END / POWER] key when you return to
the previous setting.
5
Press the key several times to
end the setting.
Set the e-mail address
1
Press the
(MENU) (>>)
key in LOCAL.
• MACHINE SETUP MENU will be displayed.
2
Press to select “EVENT MAIL” ,
and press the key.
3
Press to select “MAIL ADDRESS”
, and press the key.
4
Press to set mail
address, and press the key.
• Set the e-mail address to which you send the
event mail.
• Set it with alphanumeric characters and symbols
within 96 characters.
5
Press the key several times to
end the setting.
Set the subject
1
Press the
(MENU) (>>)
key in LOCAL.
• MACHINE SETUP MENU will be displayed.
2
Press to select “EVENT MAIL” ,
and press the key.
3
Press to select “MASSAGE
SUBJECT” , and press the key.
4
Press to set subject,
and press the key.
• Set the characters to write in the subject of the
event mail.
• Set it with alphanumeric characters and symbols
within 8 characters.
5
Press the key several times to
end the setting.
Event name Outline
PRINT
START
Sets sending/not sending of an email when
printing starts.
PRINT END
Sets sending/not sending of an email when
printing ends.
ERROR
Sets sending/not sending of an email when
printing is stopped due to occurrence of an
error.
WARNING
Sets sending/not sending of an email when a
warning occurs during printing.
OTHER
Sets sending/not sending of an email when an
event other than the above occurs.