MIMAKI UJV55-320 - Capping Station Maintenance

ii
Setting two narrow roll media (twin rolls)..........................................2-15
Setting media by using the narrow take-up device .....................2-18
Set the settings of Feeding unit and Take-up unit of Machine
Setup to “OFF” .................................................................................2-18
Lower the tension bar located on the front of the machine to its
lowest position to remove the roll shaft ............................................2-18
Set media by using the narrow take-up device ................................2-18
Set media by using the narrow take-up device (twin rolls) ...............2-19
Setting leaf media.............................................................................2-20
Removing the taken-up media .........................................................2-21
Changing the printing origin .............................................................2-22
Preparing for the Heaters............................................................2-23
Changing the Temperature Settings for the Heaters........................2-23
Test Printing................................................................................2-23
Test Printing .....................................................................................2-24
Head Cleaning ............................................................................2-24
About head cleaning.........................................................................2-24
Perform head cleaning depending on the test printing result ...........2-24
Setting of Media Correction.........................................................2-25
Setting of Media Correction.............................................................2-25
Correct the ink drop position for bidirectional printing .................2-26
Printing Data ...............................................................................2-27
Starting a Printing Operation ............................................................2-27
Stopping a Printing Operation ..........................................................2-27
Deleting Received Data (Data Clear) ...............................................2-27
Chapter 3 Extended Functions
About Setup MENU.......................................................................3-2
Setup MENU table..............................................................................3-3
Register the optimal print conditions to match the use.......................3-4
Setting of Media Correction................................................................3-5
If the Positions of Dots Shift... ............................................................3-6
Setting the Heater ..............................................................................3-6
Setting of Logical Seek.......................................................................3-7
Setting of Overprint ............................................................................3-7
Setting of Left and Right Margins ......................................................3-8
Setting of UV mode ............................................................................3-8
Setting of Refresh...............................................................................3-9
Setting of Vacuum Fan.....................................................................3-10
Setting of Print Speed ......................................................................3-10
Setting of MAPS4 .............................................................................3-10
Setting Auto Cleaning.......................................................................3-11
Setting Interval wiping ......................................................................3-11
About Machine Setup MENU ......................................................3-12
Machine Setup MENU table .............................................................3-13
Setting a AUTO Power-off................................................................3-14
Setting Feeding unit .........................................................................3-14
Setting Take-up unit .........................................................................3-14
Setting the Display of Media Remain ...............................................3-15
Setting Time .....................................................................................3-15
Setting Unit (Temperature/ Length)..................................................3-15
Setting a Key Buzzer........................................................................3-15