Operator’s Manual of Anesthesia System 9 - 21
Maintenance Cleaning and Disinfection
9.7.3.4.2 Inspiration and Expiration Valves
1. Insert the inspiration and expiration valves into the breathing system body.
Figure 9-21 Insert the inspiration and expiration valves
2. Install the valve dome to the breathing system body. You will hear a snap when the valve dome
is installed in place.
Figure 9-22 Install the valve dome
9.7.3.4.3 Breathing System Body
Hold the handrails on one side of the breathing system body and push the breathing system body
into the anesthesia system. Make sure that the two surfaces in the following figure are in the same
plane and hear a snap.
To Next Page
Loading...
