Installing Your Analyzer
4-12
Figure 4-10
4. Locate the green fitting, marked RINSE, in the lower right corner of the back of the
analyzer. Plug the blue connector of the tube into the fitting and turn it clockwise until
properly secured;
5. Locate the transducer fitting, marked RINSE, in the lower right corner of the back of the
analyzer. Connect the wire by pushing in and turning until properly secured.
Connect waste container
1. Take out the waste tube with a red connector from the accessory box;
2. Locate the red fitting, marked WASTE, in the lower right corner of the back of the
analyzer. Plug the red connector of the tube into the fitting and turn it clockwise until
properly secured;
3. Prepare a container to receive the waste and place it on or below the countertop;
4. Insert the waste tube into the waste container.
To Next Page
Loading...
