Mindray BeneVision N Series

20 - 10 BeneVision N Series Patient Monitor Operator’s Manual
The numeric area does not display ScvO2 or
SvO2 values when the Vigilance II, Vigileo,
EV1000, or HemoSphere monitor is connected.
1. Check that the ScvO
2
or SvO
2
is set to display in the Screen Setup
menu
. For more information, see
3.11.2Displaying Parameter Numerics
and Waveforms
.
2. Check that if the ScvO
2
/SvO
2
parameter switch is enabled. If not,
enable the ScvO
2
/SvO
2
measurement. For more information, see
3.11.1Switching On or Off a Parameter.
3.Check that the Vigilance II, Vigileo, EV1000, or HemoSphere monitor is
set properly as described in
20.5Connecting the Device.
4. Check the connection of CCO/SvO
2
cable. For more information, see
20.5Connecting the Device.
Problem Solution