BeneVision N Series Patient Monitor Operator’s Manual 3 - 21
3.16 Capturing the Screen
The monitor provides the function of screen capture. To capture the current screen display, follow this
procedure:
1. For N17/N15/N12/N12C, connect the USB drive with the licenses in to the monitor’s USB connector. For
N22/N19. connect the USB drive to the monitor’s MSB connector.
2. Press and hold the More quick key. Wait till it turns from blue to grey.
The captured pictures are automatically saved in the USB drive.
3.17 Checking Software Licenses
To run the following functions in your monitor, software licenses are required:
■ BoA Dashboard
■ HemoSight
■ SepsisSight
■ Early Warning Score (EWS)
■ CQI
■ CPR Dashboard
■ ECG 24H Summary
■ Pace View
■ Remote Screen
To check the licenses, select the Main Menu quick key → select License → Local.
To install the licenses, follow this procedure:
1. For N17/N15/N12/N12C, connect the USB drive with the licenses in to the monitor’s USB connector. For
N22/N19. connect the USB drive to the monitor’s MSB connector.
2. Select the Main Menu quick key →select License → select External.
3. Select Install.
3.18 Turning Off the Monitor
Before turn off the monitor, perform the following check:
1. Ensure that the monitoring of the patient has been completed.
2. Disconnect the cables and sensors from the patient.
3. Make sure to save or clear the patient monitoring data as required.
To turn off the monitor, press and hold the power switch for 3 seconds.
Turning off the monitor does not disconnect the monitor form the AC mains. To completely disconnect the
power supply, unplug the power cord.
• Press and hold the power switch for 15 seconds (for N22/N19) or 10 seconds (for N17/N15/N12/
N12C) to forcibly shut down the monitor if it could not be shut down normally. This may cause loss of
patient data.
• The monitor that was switched on prior to a power loss automatically switched on when the power is
restored.
• In case of a temporary power failure, if the power is restored within 30 minutes, monitoring will
resume with all active settings unchanged; if the monitor is without power for more than 30
minutes, the monitor behaves the same as it is normally turned off.
To Next Page
Loading...
