II
and digital board assembly in 8 chapter.
3. In 9.3.6, add digital board assembly and COME module assembly
procedure for DC-8 EXP
4. 9.3.9.7 chapter add digital keyboard assembly procedure for DC-8
EXP.
5. Update appendix C self-diagnosis chapter.
6. 10.2.7 chapter updates gel warmer cable connection description.
7. 10.1 chapter adds Promote function description.
1. 2.1.3 add video printer UP-X898MD and UP-D898MD, and mark the
printers that is supported only on XP operating system.
2. 3.4.3.3 Wireless printer is not supported by the DC8 series products
later than V4.0.
3. 3.5.5 update the descriptions and screen shots for wireless network
settings.
4. 3.5.7 Update the picture for Setup-About page。
5. Chapter 8: add to PC FRUs, and delete the old PC FRU used for DC8
EXP which is no longer served as FRU.
6. Add digital board FRU used on non-EXP in Win7.
7. Add Hard disk used in OS Win7 for DC-8 non-EXP and EXP in the
region of CE/FDA/India/Russia & CIS.
8. 10.1 Add picture of the screen for Promote function. Update screen
picture for uninstalling the options.
9. In section 9.3.6.2, 9.3.9.7 and 10.2.1, change the steps for DC-8 EXP
only or for non DC-8 EXP only to “for win7” and “for XP”.
1. Section 10.2, change part number and picture of the gel warmer.
Section 10.2.7 change pictures in step of installing the gel warmer.
2. Section 11.1.5, add the status indicator of the gel warmer.
3. Section 11.3.6, add the abnormality of the gel warmer.
Change the WIFI disassembly.
Add 10.2.8 for WIFI module update; add new WIFI package part number in
10.2
Update the labels in 1.2.2
Update part number of Probe Board Assembly (spare part)
Add part number of gas spring assembly
1. Section 2.2.4.1, change the size of main monitor
2. Section 6.6, change the HDD partition
3. FRU chapter, add 23.8 inch monitor and update part number of DSP
board.
© 2011-2018 Shenzhen Mindray Bio-medical Electronics Co., Ltd. All Rights Reserved.
To Next Page
Loading...
Need help?
General
