10-18 Optional Installation/Assembly
10.2.7 Gel Warmer
1. Assemble the gel warmer under the control panel by following the direction shown in the
figure.
2. Connect the gel warmer power wire to the socket under control panel to finish the assembly.
10.2.8 WIFI Module Update
See 9.3.4 chapter for WIFI module assembly/disassembly.
Released versions higher than EED038-F of DC-8 and DC-8 Exp support this WIFI module
update.
Please refer to the following chart for update process.
To Next Page
Loading...
Need help?
General
