Software Installation &Maintenance 6-3
6.4 Software maintenance
6.4.1 Product Configuration
[Config] is available on the Maintenance menu only if the operator logged on the
system as Service.
1. Make PCF file according to the product (made in the factory, for special models, the PCF file is
already archived), then copy it to the USB disk. Insert the USB disk into the USB port; click
[Config] on the maintenance menu to open the following dialogue box.
2. Select correct PCF files, and click [OK]. After the operation is completed, the successful prompt
appears. Restart the system and the configuration takes effect.
Special configurations including:
Dedicated product LOGO, hospital LOGO, dormant/screen saver logo, image active/inactive
symbols in dual B mode, system information, system start-up/shut down screen, etc.
System general configuration is already configured during the resume
package restoration. No manual configuration is required if no special
requirement.
Don’t change the model of the machine; otherwise the key files may be lost.
6.4.2 Log Maintenance
6.4.2.1 Export the Log
This operation can be performed by both internal and external users.
To Next Page
Loading...
Need help?
General
