Structure and Assembly/Disassembly 9-1
9 Structure and
Assembly/Disassembly
9.1 Structure of the Whole System
9.2 Preparation
9.2.1 Tools Required
Cross-headed screwdriver : One，specification: 105X100
Anti-static gloves: one pair
9.2.2 Requirement for Engineers
Only technical professionals from Mindray or engineers authorized by Mindray after training
can perform assembly and disassembly.
9.2.3 Assembly/Disassembly Requirements
You should make the following preparations before disassembling of ultrasound equipment.
1. When you stop scanning and capturing image, you should power off the system and
disconnect the system from the AC power supply, then pull out AC power cable.
2. Lock the casters to prevent accidental movement during assembly and disassembly.
3. Prepare the tools.
9.3 Assembly and Disassembly
This section describes the disassembling and assembling of the main assemblies and boards.
Assembly procedure is inverse with disassembly procedure if no special explanation
Disassembling scheme
To Next Page
Loading...
Need help?
General
