System Installation 3-7
2. Push the retaining clamp downward, and lock the power cord, as shown in the figure (b) above.
3. Plug the other end power plug into an appropriate outlet. The grounding terminal should be
connected with a power grounding cable to ensure that protective grounding works normally.
Make sure to allow sufficient slack in the cable so that the plug is not pulled out of the
wall if the system is moved slightly.
3.3.3 Connecting ECG
Connect the ECG cable to the corresponding interface on the physio panel.
3.3.4 Install Endocavity probe bracket
Fix the endocavity probe bracket with two M4X12 screws as follow:
To Next Page
Loading...
Need help?
General
