Mindray Eagus TEX21 - Data Export; Application; Iworks (Auto Workflow Protocol); Overview

6 Image Acquisition
Operator’s Manual 6 - 43
Comments and Body Mark operations are the same as those of other modes.
6.21.8 Data Export
The system provides data exporting function, so that you can export calculation result for analysis
(for instance, SPSS analysis).
Tap [Data Export] to export analyzed data of each segment in .csv format.
6.22 Application
This function is used to evaluate respiratory failure, shock and trauma in emergency treatment,
quickly determine the cause of respiratory failure, identify the type of shock, and determine
whether there is fluid in the trauma.
Perform the following procedure:
1. Select a probe and click [Application] in Function menu to enter an application.
2. Select the site or section for scanning.
– Select [Help] to view help information about the scanning of the section.
– Select [Setup] to set the section type.
3. Adjust the image parameters, select the annotation information, and save the image.
4. Repeat step 2~3 to scan all parts and sections.
5. Click [Summary] to view all comments and images.
6. Click [End Application] to end the exam.
6.23 iWorks (Auto Workflow Protocol)
6.23.1 Overview
The main objective of ultrasound workflow automation (iWorks) is to speed up exam times and
reduce the excessive number of user interface manual key strokes that can lead to repetitive strain
injuries over time. It automates a clinical workflow in common exam protocols in a logical “step by
step” manner. It also prevents missing important parts of examinations as well as decreasing exam
times.
A Protocol Event contains series workflow events (annotation comments, body marks and
measurements) and image modal commands to assist the user in routine ultrasound examinations.
The system provides different protocol events based on the different application regions.
6.23.2 Normal iWorks Basic Procedure
Perform the following procedure:
1. Enter the patient information.
2. Select [iWorks] to enter the protocol selection screen, and select the corresponding protocol to
enter the status.
3. After the system enters the iWorks screen, the available protocol is displayed. Perform the
scanning and saving according to the screen prompt.
Perform measurements or add comments/body marks to the image according to the screen
prompt.
4. After a view scanning is complete, tap [Save Image] to switch to the next view according to the
screen prompt.