1 - 6 Operator’s Manual
1 Important Information
• Use detachable power supply cord as mains power breaking device. DO NOT set equipment in
place where difficult for disconnection of detachable power supply cord.
Please read the following precautions carefully to ensure the safety of the patient and the operator
when using the probes.
• The ultrasound probe is only for use with the specified ultrasound
diagnostic system.
• The ultrasound probe must be used only by qualified professionals.
• Confirm that the transducer and probe cable are normal before and after
each examination. A defective probe may cause electric shock to the
patient.
• Do not subject the probe to shock. A defective probe may cause electric
shock to the patient.
• Do not disassemble the probe to avoid the possibility of electric shock.
• Never immerse the probe connector into liquids such as water or
disinfectant because the connector is not waterproof. Immersion may
cause electric shock or malfunction.
• A transducer sheath must be installed over the transducer before
performing examination.
• When using a probe, pay attention to the status of the ultrasound image.
Do not use the probe to perform image acquisition when the image is
frozen.
• When using the probe, wear sterile gloves to prevent infection.
• Please use the ultrasound gel com-pliant with the relevant local
regulations. And manage the ultrasound gel properly to ensure that it does
not become a source of infection.
• In normal diagnostic ultrasound mode, there is no danger of a normal-
temperature burn; however, do not keep the probe on the same region of
the patient for more than 10 minutes to avoid risk of burn.
• Do not use the carrying case for storing the transducer. If the carrying case
is used for storage, it may become a source of infection.
• It is required to practice ALARA when operating ultrasound system.
Minimize the acoustic power without compromising the quality of images.
• The probe and accessories supplied with it are not delivered disinfected or
sterilized. Sterilization (or high-level disinfect) before use is required.
• Disposable components should be packaged sterile and for single-use
only. Do not use if integrity of packaging violated or if expiration date has
passed. Please use the disposable components compliant with the relevant
local regulations.
To Next Page
Loading...
