5-14
NOTE
z You can cut part of the tubing if it is hard to be removed from the gas nipple.
z Avoid damaging the tubing when taking out the watertrap assembly.
z When reinstalling, fix the tubings with plastic clamp and do not fold the tubings.
To remove microstream CO2 assembly:
1. Release the plastic clamp and take out the tubings. Then release the four clips in the
directions as indicated with a flat-bladed screwdriver. Then separate the microstream
CO2 interface panel and the front panel.
2. Move the microstream CO2 interface assembly through the fixer in the way as shown
below.
To Next Page
Loading...
