4 - 48 Operator’s Manual
4 Setup
4.11 Security
4.11.1 Drive Encryption/Secure Data Wipe
Encrypt the patient data stored in the hard disk. The system provides two encryption methods:
Factory Default and User Define.
• Factory Default: the system is in factory state by default.
• User Define: add a user-defined password.
Perform the following procedure:
1. Select [User Define].
2. If no patient data are stored in the hard disk, click [Confirm], input the password and click
[Confirm] to finish the password setting
If the patient data are already stored in the hard disk, the system will pop-up prompts, follow
the steps below:
a. Click [OK].
b. Click [Wipe] and operate according to the screen prompts to clear patient data.
c. Select [User Define] again, and click [Confirm].
d. Input the password and click [Confirm] to finish the password setting.
• If you want to switch to Factory Default, perform steps above again. The password is the same
as that of the User Define.
• When you set password, multi-language and Chinese characters are not supported.
4.11.2 Anti-Virus
The system provides two anti-virus software: Windows Defender and McAfee. They can
effectively prevent the ultrasound system from being attacked by virus, spyware, or other malware.
If the McAfee software is installed, the system displays “McAfee is installed”; if not, the system
displays “McAfee is not installed”. The McAfee software is an option. If you want to buy McAfee,
contact Mindray service engineers.
To Next Page
Loading...
Need help?
General
