Introduction Continuous Cardiac Output (CCO) & Continuous Hemodynamics (Optional)
1 - 2 Addendum to V Series Operating Instructions
1.1 Introduction
This chapter describes how to obtain Continuous Cardiac Output (CCO) and Continuous
Hemodynamic values from the Edwards Vigilance, Vigilance II, Vigileo, and EV1000 monitors; and how
to monitor and configure the alarm limits of the monitors. The Continuous Hemodynamic values are
calculated from the CCO values.
Patient Sizes
Intended patient types: Adult and Pediatric.
VDI Module Connector
The VPS module does not include the CCO parameter. The CCO parameter is available through the
serial port of a separate module called the V Device Integrator (VDI) (as shown in FIGURE 1-1).
FIGURE 1-1 Example VDI Module Connector
Display Setup
To see the CCO and Hemo values, CCO and Hemo tiles must be configured to display on the Main
Screen. Refer to "Display Options Dialog" on page 3-2 in the V Series Operating Instructions for
additional information.
1.2 CCO/Hemo Configuration
The CCO dialog (as shown in FIGURE 1-2) contains an Alarms tab and a Setup tab.
The Hemo dialog (FIGURE 1-3) contains a Parameters, Alarms and Setup tab.
A description of each tab follows.
1.2.1 Navigating to the CCO Dialog
• Select the CCO or Hemo digital tile.
OR
1. Select the Set
up tab from the Navigation Area.
2. Select the Parameters button.
3. Select the CCO
button for the CCO dialog or
select the Hemo button
for the Hemo dialog.
The CCO or Hemo dialog is displayed (as shown in FIGURE 1-2 and FIGURE 1-3).
To Next Page
Loading...
Need help?
General
