7-16
(3) Zeroing settings: Select [Main], and select [Setting] > [ENTER] > [Zero Mode] >
[Manual] > [BACK] > [BACK].
(4) Serial port mode settings: Select [Main], and select [Setting] > [System] > [Enter] > [Serial
Mode] > [OTIS Ctrl] > [BACK] > [BACK].
(5) The calibration goes into the serial port mode interface after the VT Plus is configured.
Set FPM as follows if FPM is selected as the calibration device:
(1) Start the machine and wait until the sensor is pre-heated.
To Next Page
Loading...
