Mindray WATO EX-65Pro - Page 448

10-10
Figure
No.
Part Number Description Qty FRU Remark
1 115-025506-00 Battery box assembly (0625) 1
No /
2 042-014912-00
Metal sheet bracket of hardware box
(0625/silkscreen)
1
No /
3 048-004559-00 Cotton cushion of mother plug (0625) 1
No /
4 051-002637-00 0627 mother board PCBA 1
Yes /
5 M04-051140---
cross recess head screw combined assembly
GB/T9074.8 M3X8, green color zinc
plating
35
No /
6 M04-000018--- Stud screw, M3X20+8-8, rust nickel plating 3
No /
7 051-000685-00 0631 power board PCBA 1
Yes /
8 M04-011002---
Hex nut countersunk external toothed lock
washer combined assembly, M3, green
color zinc plating
1
No /
9 115-050879-00 0625 monitor assembly 1
Yes /
10 042-012481-00 Monitor tray plate (0625) 1
No /
11 047-015696-00
Heat conduction pad of main control board
(0625)
3
No /
12
115-040736-00
Main control board (with BIOS + system
software)
1
Yes /
115-040643-00
Main control board (VCV+PCV)(0627
maintenance)
Yes /
13
115-042876-00 3-way valve assembly (ASCO/0625/3)
1
Yes /
115-042877-00 3-way valve assembly (ASCO/0625/4)
Yes /
14 082-000111-00 PMT 1/4-28UNF 4
No /
15 M90-100012---
Lock Nut, Panel Mount,1/4-28UNF,White
Nylon
4
No /
16 009-004706-00 0625 connection line of monitor module 1
Yes /
17 A21-000007--- Hose. Silicone, 3/32"X7/32"X100ft 4.3m
No /
18 M90-100030---
Connector. Y, 200Barb, 1/8"ID, White
Nylon
2
No /
19 M05-010R03--- Button cell Lithium, 3V35mAh D12.5*2.0 1
No /
20 047-014692-00
Pipe connection label of monitor board
(0625/ without pressure monitoring)
1
No /
Proceed as follows when you replace the main control board:
1. Before the replacing of the main control board, record the settings in the Factory Setup
menu (choose [Main] > [Service] and then enter the password to access the factory
setting menu.).
2. After the replacing of the main control board, confirm whether the settings in the
Factory Setup menu are same with the record.
3. If not, change the settings in the Factory Setup menu and make sure the settings are
same with the record. Then start the machine and confirm the consistency again.