3-14
7. Insert the air pump into the power socket.
8. Close the upper cover by two thirds from the front of the air compressor along the guide
groove, connect the gas hose of the pressure gauge and indicator plug, push the upper
cover to the proper position, tighten the five screws in the rear, and stick the three safety
stickers to the positions circled in black, as shown in the following figure.
9. Use two screws to fix the front panel of the air compressor on the cart from the
front.
Air pump power
socket
Connect the cable materials and
i
elines of the u
er cove
Positions circled in black for safety stickers
and
ositions circled in red for screws
To Next Page
Loading...
