Mindray Z60T User Manual

12-4 Setup
Type
Item
Description
Enable Standby
Available after “Enable ScreenSaver” is selected.
Select Picture
After screen saver function is enabled, click [Browse] to
select the figure used for screen saver, and click
[Preview] to see the effect.
Exam Setup
Status after exam
ends
Select to enter the imaging scanning, patient info or the
Worklist after ending an exam.
Display
Color temperature Cold/ Warm
Brightness/Contrast
Load Factory
Load the factory data of the display brightness and
contrast.
12.1.3 Image Preset
Open the Image Preset page via [Setup]-> [System Preset]-> [Image], as shown in the figure
below.
Type Item Description
Reset Config
Probe
To set the default probe model for the system.
/ MITI
To set MI TI indexes displayed for current probe/exam
mode.
Freeze
Config
Status after Freeze To set the system status after image is frozen.

Mindray Z60T Specifications

General

Brand	Mindray
Model	Z60T
Category	Diagnostic Equipment
Language	English