12-12 Setup
Add a network service:
1. Set the network server properties as described above.
2. Click [Add] to add the service to the Service list;
3. Select the added service in the service list, you can delete it.
Modify a network service:
1. Select the service to be updated in the service list.
2. You can see properties in the Configure Service area.
3. Modify the parameters and click [Update] to update setting.
Tips: in order to make network storage function normally, setting of the sharing folder of the
PC server in advance is a must, e.g. machine name, IP address, should be confirmed at first.
You can send exam data of images to iStorage server by UltraAssist. For details about this
feature, please refer to the UltraAssist manual.
12.7.2 MedSight Preset
You can set environment for MedSight here and then use the MedSight function by mobile
phone or tablet computers. See MedSight manual for details.
12.8 Maintenance
In the Setup menu, select [Maintenance] enter the screen.
12.8.1 Option
The system enters Option page after you enter the Maintenance screen. In Option list, the
system lists out all the system supported options and the installation status (Not installed or
Installed).
Install and uninstall
Click [Install] to begin the installation of a disabled option.
Click [Uninstall] to begin the un-installation of an already installed option.
Trial
Select the option item in the list to see the information on the Comment region on the
right. For functions that are not configured, you can use the function for free for 3 months.
Click to select the function(s) and click [Trial].
Tips: Every trial option can be used only once. Please refer to the dependence
relationship between options in chapter “2.5.3 Options”.
Please contact Mindray Customer Service Department or sales representative for details.
12.8.2 Probe Check
This function enables users to check if a transducer element is in malfunction, so as to
evaluate the transducer performance.
On B mode, enter [Setup]-> [Maintenance] -> [Probe Check] to open the the Probe
Check screen. If a transducer element is in malfunction, it is displayed as a red spot. If a
transducer element functions well, it is displayed as a green spot.
You can click [Export] to export the result to the external device.
To Next Page
Loading...
Need help?
General
