Preliminary
miniDSP Ltd, Hong Kong / www.minidsp.com / Features and specifications subject to change without prior notice 37
6.4.4 Subwoofer integration (2.1 system)
The connections for integrating a single subwoofer are a simple addition to the one shown on the previous page:
On the Outputs tab:
• Rename the output channels (from left to right) to “Left Sp”, “Right Sp”, “Sub” and “Unused”.
• Mute channel 4 (“Unused”).
• Set a high pass crossover filter on channels 1 and 2 (“Left Sp” and “Right Sp”). For example:
• Set a low pass crossover filter on channel 3 (“Sub”). For example:
On the Inputs and Routing tab, set the routing matrix like this:
We recommend that you do acoustic measurements to check and fine-tune your subwoofer crossover settings,
as described in this application note on our website:
• Subwoofer Integration with the miniDSP SHD and REW
To Next Page
Loading...
