Preliminary
miniDSP Ltd, Hong Kong / www.minidsp.com / Features and specifications subject to change without prior notice 40
6.4.7 Two-way active speaker
The miniDSP Flex can implement a two-way active speaker. This diagram illustrates a typical set of connections:
On the Outputs tab, rename the output channels to “Left W”, “Right W”, “Left Tw”, and “Right Tw”.
On the Routing tab, set the matrix like this:
On the Outputs tab again:
• Use REW to measure each individual driver (woofer and tweeter) and equalize their response flat with
the PEQ blocks. This procedure is the same as for the 2x4 HD, as described in the application note
Designing a 2-way active speaker with the miniDSP 2x4 HD on our website.
• Set up your high pass and low pass crossover filters. This procedure is the same as for the 2x4 HD, as
described in the application note linked above. This is a typical low pass setting for the woofers:
This is a typical high pass setting for the tweeters:
To Next Page
Loading...
