Fixes the reel to the feeding gear, maintains the gap to take of vinyl,
and guides the shutter that controls movement of chip.
Feeds the reel to the set pitch.
Used to fix the feeder to the feeder base.
Generates feeding by movement of motor
Displays the number of slot inserted to the feeder base, or the error
code if a problem occurs in the feeder. Displays the pitch of the
feeder.
Used to take off the tape from the reel.
Collect the removed vinyl. & winds it.
Controls feeding manually after the reel is mounted.
The contact made of 8 pins that supply power to the feeder and
connection communication path to the main body.
Consists of two pins in the front and 1 pin on the bottom, fixing
the feeder to the feeder base and controls change of picking
position.
Moves the reel in accordance with the pitch.
In case of problem, initialize the feeder drive status.
The linear motor used for feeder only. It is used permanently by
replacing the worn part only without replacing the brush.
Controls movement of chip and increases stability of feeding.
To Next Page
Loading...
