iii
SAFETY INSTRUCTIONS
Incorrect or insecure handling can cause personal injury or malfunction of the
equipment, therefore, be sure to keep the following instructions.
1. For safe operation, read this manual thoroughly. Refer to the maintenance
manual for safety signs. For safety mark, refer to maintenance manual
(Maintenance) part.
2. Check the location of Emergency Switch before you start operating the
machine. In case of emergency, be sure to stop equipment immediately.
3. Do not operate the machine with wet hands.
4. Before you open any door or cover, make sure to power off the machine.
5. Do not operate the machine after setting the door safety sensor. Manipulation
of safety sensor performed by anyone other than the authorized personnel
may cause malfunction.
6. Before starting the machine, check all safety instructions, especially, in case of
operation of multiple operators, check the other operator’s security first and
start operation.
7. Be cautious to keep electrical parts (e.g., VME Rack, Power Box, Amp, PC,
and Boards) away from water or oil.
8. Be sure to power off the machine before disassembling all connector.
9. Be sure to power off the machine before dissembling any connector.
10. Do not operate the machine in the state of excessive high temperature, dust,
noise, or air pressure.
11. Do not operate the machine in the location with combustible gas, pollution or
dust.
12. Never insert hand, head or other part of the body into the machine while it is
running.
13. Do not use the PC for other purposes than operation of the machine. The
machine may be infected with computer virus.
14. Do not permit persons who did not receive operating education to operate the
machine
15. Only the qualified personnel who received maintenance education from
MIRAE must perform maintenance to the machine.
16. Contact the service center of Mirae Corp. for any job not described in this
manual.
17. Never perform a job at your own discretion.
To Next Page
Loading...
