3-4 Offline Feeder Setup Manual
If you select '’Yes', the
label is so small that the
page is not normally
printed.
9. "Share
Printer"
window
appears.
Select “Not Share” and click ‘Next’.
10. "Print Test Page" window appears. Select 'No' and click ‘Next’.
11. "Printer Add Wizard Complete" window appears. Click 'End'.
12. If the printer model is compatible with ELTRON TLP2742, you shall download the logo
image once.
Run Offline Feeder Setup program.
Click the "Setup" button, and select Printer tab.
If the button has been disabled, click Disconnect button.
Or, click "Barcode Print" and then click "Setup".
Select ELTRON TLP2742 from Model List box, and click
Download button. If the file does not exist in the current directory,
Open window appears. Here, find and select "Mirae1.pcx" and
click Open button.
13. To check whether the printer has been normally set up, perform the following
sequence:
Run Offline Feeder Setup program, and click the "Barcode
Print" button.
"Barcode Print" window appears where the name of the
selected printer, port, spool status, and the remaining amount of
printing are displayed on the Status Bar.
If the printer driver has not been correctly set up, such
information is not displayed. In this case, you shall reinstall the
driver.
Select Part tab in "Barcode Print" window, enter any part
number and the quantity and click 'Print'.
If the information displayed on the "Barcode Print" window is
printed as it is, it means that the printer driver has been correctly
set up.
To Next Page
Loading...
