Mircom FX-401 User Manual

40
• Clearing Logs
• Walk Test Function
• Bypass Operation
• Disconnecting Auxiliary Relays
• Testing the Dialer
• After Hours Operation
• Clearing Verification Counts
• Ground Fault Testing - Factory Use Only
Complete configuration of the system is done via the software configurator.
How to Enter the Operation Menu
1. Press the Menu button.
2. Use the DOWN Cursor key to scroll to 3. Operation and press the Enter button to enter
the Operation Menu.
Figure 10 Operation Menu
3. To select an Operation use the DOWN Cursor key to scroll to desired choice and press
the Enter button.
5.11.1 Setting the Time
Sets the current date and time for the panel. Use the ‘#’ key to move the cursor forward and
the UP and DOWN key to change the date/time parameters.
Note: Option 8. Test Dialer will only appear if there is a UDACT on-board.
- Operation Menu -
1. Set Time
2. Set Password
3. Reports
4. Clear logs
5. Walk test
6. Bypass
7. Aux. disc.
8. Test UDACT
9. After hours
10. Clear ver.cnts
11. Gnd.Fault test
12. Positive Alarm
13. Exit
i
Date : Oct 08, 2005
Time : 10:00 PM

Mircom FX-401 Specifications

General

Brand	Mircom
Model	FX-401
Category	Control Panel
Language	English