Mitsubishi Electric MELSEC-L Series LD40PD01 - Page 221

13 PROGRAMMING
13.3 When the Module Is Connected to a Head Module
219
13
Settings on the master station side
1. Create a project of GX Works2.
Select "QCPU (Q mode)" in "Series" and select "Q10UDH" in "Type".
[Project]  [New]
2. Display the setting window for the network parameters and set the values as follows.
[Project window]  [Parameter]  [Network Parameter]  [Ethernet / CC IE / MELSECNET]
3. Display the setting window for the network configuration settings and set the values as follows.
[Project window]  [Parameter]  [Network Parameter]  [Ethernet / CC IE / MELSECNET] 
button