Chapter 6
74
Connecting to the MELSEC-WS safety controller
Click on the Scan button. Your network is scanned for connected network
modules and the network modules found are displayed in the list.
Click on the desired network module. The IP address of the device is displayed in
the IP address field.
Enter a name for the new profile.
Click OK. The dialog is closed and the new profile is displayed in the list.
To activate the new profile, select it using the left mouse button and click on the
green arrow symbol at the right. From now on, the Setting and Monitoring Tool
will use this profile.
How to check a profile:
Click on the green tick on the right side of the profile to be checked.
To check all profiles, click on the Check all profiles button.
The Setting and Monitoring Tool checks the connection settings and marks faulty
profiles.
Profile type Profile not checked Profile OK Profile faulty
Serial (COM)
USB
TCP/IP
Figure 45:
List of network modules
found
Table 11:
Status symbols for
connection profiles
To Next Page
Loading...
