Mitsubishi Electric WS0-CPU0 - Page 78

Chapter 6
75
Connecting to the MELSEC-WS safety controller
How to change the network settings of a network module:
 Click on the Network settings button. The Network scan dialog is opened.
 If necessary, select the correct network adapter from the dropdown list at the
bottom of the dialog.
 Click on the Scan button. Your network is scanned for connected network
modules and the network modules found are displayed in the list.
 Click on the network module you want to edit.
 Enter the new settings in the Edit IP address area.
 Click on the Set device config button to transfer the new settings to the device.
Figure 46:
List of network modules
found