Chapter 7
83
Flexi Link
Use the up and down arrow buttons or drag and drop the stations into the rows for
Station A to D so that no two stations occupy the same address.
There are two possibilities to identify each station:
– Click on the Start identify button of one of the displayed stations. The
corresponding station’s MS and EFI1 LEDs will start flashing alternating with the
EFI2 LED (2 Hz). You will need the password for Administrator. The default
password is “MELSECWS”. To stop the LED flashing, click the button again (it
is now labeled Stop identify).
– Check the serial number on the memory plug and compare it with the serial
number shown in the Setting and Monitoring Tool.
Click on the Apply settings button in the upper left hand corner of the screen. The
Flexi Link addresses of the stations will be changed.
Figure 49:
Flexi Link Network settings
without valid address
assignment
Figure 50:
Apply settings button
Figure 51:
Flexi Link Network settings
with valid address
assignment
To Next Page
Loading...
