Chapter 7
84
Flexi Link
Step 3: Read in the hardware settings
Click on the System overview tab. The following view opens:
Click on the Upload button. The Setting and Monitoring Tool will read in the
hardware and configuration settings of all devices on this station.
When the hardware configuration is complete, click Disconnect. You can now
configure your project as described in Section 7.3.3.
The Disconnect command in the System overview will disconnect all Flexi Link
stations simultaneously. The buttons for Transfer and Upload react the same way as
well. If you switch to the view for an individual station, these buttons will affect only that
station.
Figure 52:
Flexi Link System overview
Note
To Next Page
Loading...
