Chapter 7
88
Flexi Link
Assigning tag names for the Flexi Link routing
Still in the Station A view, switch to the Flexi Link routing table using the Flexi Link
station A button in the toolbar (if your project contains also one or two network
modules, you will find this entry in the submenu under Network modules).
Click on Byte 0 in the EFI1 area to display the tag names for Byte 0 and its bits in
the lower half of the window.
Now replace the default tag names (e.g. Safe 0.3 and Safe 0.4) with more
expressive tag names (e.g. Global Reset and Global E-stop). The assigned tag
names will be displayed in the logic editor from now on.
It does not make a difference for the routing whether you use the default tag names or
change them, but assigning clear tag names will help you to keep track of things in
your projects.
Figure 58:
Flexi Link routing table and
tag names
Figure 59:
Assigned Flexi Link tag
names in the routing
configuration and in the logic
editor
Note
To Next Page
Loading...
