690
FX3G/FX3U/FX3GC/FX3UC Series
Programming Manual - Basic & Applied Instruction Edition
30 External Device Communication (Inverter Communication) – FNC270 to FNC275
30.6 FNC275 – IVMC / Inverter Multi Command
3. Related devices
→ For the instruction execution complete flag use method, refer to Subsection 6.5.2.
*1. Cleared when PLC power supply is turned from OFF to ON.
*2. Cleared when the PLC mode switches from STOP to RUN.
*3. Initial value: -1
Cautions
→ For other cautions, refer to the Data Communication Edition manual.
• It is not permitted to use an "RS (FNC 80)/RS2 (FNC 87)"/"FLCRT (FNC300) to FLSTRD (FNC305)" instruction and
an "IVCK (FNC270) to IVMC (FNC275)" instruction for the same port.
• Two or more inverter communication instructions (FNC270 to FNC275) can be driven for the same port at the same
time.
• Number of occupied devices
Two devices are occupied respectively by and .
Make sure not to use those devices in another control.
• If a device number outside the range due to indexing, etc. is specified in , the receive data from the inverter
is not stored in . However, values set in and +1 may be written to the inverter.
• If any unspecified value is set in , unexpected data may be written to and read from the inverter, and values
of and +1 may be updated.
• IVMC instruction reads the inverter status at the time of communication with the inverter, and stores the read status
to . Accordingly, the status written by the IVMC instruction can be read by a next or later read instruction
(IVCK or IVMC).
Applicable inverters
This instruction is applicable to the following inverters:
- FREQROL-E700(February 2009 and later)
- FREQROL-D700(Applicable in all)
→ For details, refer to the respective inverter manual
Applicable programming tool
This instruction is applicable to the following programming tools:
•FX3U/FX3UC Series PLCs
•FX3G Series PLC
•FX3GC Series PLC
Number
Description
Number
Description
ch1 ch2 ch1 ch2
M8029 Instruction execution complete D8063 D8438
Error code of serial communication error
*1
M8063 M8438
Serial communication error
*1
D8150 D8155
Response wait time in inverter communication
*1
M8151 M8156 Inverter communicating D8151 D8156
Step number in inverter communication
*3
M8152 M8157
Inverter communication error
*2
D8152 D8157
Error code of inverter communication error
*2
M8153 M8158
Inverter communication error latch
*2
D8153 D8158
Latch of inverter communication error occurrence step
*2*3
M8154 M8159
Inverter instruction error
*2
D8154 D8159
IVBWR instruction error parameter number
*2*3
Model name (Media model name) Compatible Versions Remarks
GX Works2 (SWDNC-GXW2-E) Ver. 1.48A or later
FX-30P Ver. 1.20 or later
Model name (Media model name) Compatible Versions Remarks
GX Works2 (SWDNC-GXW2-E) Ver. 1.62Q or later
Model name (Media model name) Compatible Versions Remarks
GX Works2 (SWDNC-GXW2-E) Ver. 1.77F or later
S
3
D
D
D
S
3
S
3
S
2
D
D
D
To Next Page
Loading...
Need help?
General
