Mitsubishi Pajero II

Sulakkeen vaihto
HN29C-A
1. Ennen unden sulakkeen asenta-
mista kytkekaa aina kyseessa oleva
virtapiiri pois paalta ja kaantakaa
moottorin kytkin "LOCK" (Iukko)-
asentoon.
2. Irrottakaa sulakerasian kansi .
3. Katsokaa sulakkeen
koko sulake-
taulukosta.
4.
5.
278
Sulakerasiassa (ajoneuvon sisassa)
on sulakkeen vedin. Ottakaa ensin
sulakkeen
vedin esiin sulakerasiasta
ja sen jalkeen vetakaa sulake suo-
raan irti sulakerasiasta kayttaen
apuna tata vedinta.
Jos se ei ole
palanut, vika on jossain muualla,
joten ottakaa yhteys valtuutettuun
MITSUBISHI-huoltoliikkeeseen, ja
tarkastuttakaa asia.
Asentakaa uusi,
samankokoinen su-
lake lujasti paikalleen.
Palanut sulake/ Kunnossa oleva
Brown fuse sulake/OK
It; ;{.7
~ @5 I!!I
72K205
Changing a fuse EN29C-A
1. Before replacing a fuse, always turn
off the electrical item concerned
and set ignition key in "LOCK" po-
sition.
2. Remove the fuse housing cover _
3. Referring to the fuse load capacity
table, check the fuse pertaining to
the problem.
4.
5.
There is a fuse puller in the fuse
housing (inside the vehicle). First
pull the fuse puller out of the fuse
housing and then by using the fuse
puller, pull the fuse straight out
from the fuse housing. If it is not
blown, something else must be
causing the problem; contact an au-
thorized
MITSUBISHI dealer to
have the problem checked.
I nsert a
new fuse of the same ca -
pacity securely into the clip.