Mitutoyo EJ-102N - Page 10

viii
No. 99MBC139A
■Intended readers and purpose of this document
●
Intended readers
Thisdocumentisintendedforrst-timeusersofEJCounters.
●
Purpose
The purpose of this document is to help you understand operation, functions, procedures for use and
care of the product.
■How to read this document
10
No. 99MBC139A
2 Setup
2.1.2 Linking Multiple EJ Counters
Up to eight EJ Counters can be linked together.
The optional interface units can also be linked together.
1 Attach EJ Counters to the DIN rail one at a time.
Tips
For details, see "2.1.1 DIN Rail Attachment / Removal" on page 9.
2 Remove the protective cover from the counter linkage connectors of EJ Counters to be linked
together.
NOTICE
Leave the protective covers in place on EJ Counters that are not to be linked. Leaving the connectors uncov-
ered could result in introduction of noise, accumulation of contaminants on the terminals, or damage to the
product.
3 Link EJ Counters together.
Slide the EJ Counter to be connected along the rail so that the counter linkage connector (female) is
NOTICE
Do not link more than eight EJ Counters together. Failure to observe this precaution may result in damage.
Tips
When sliding EJ Counters along the DIN rail, move them slowly.
Indicates an operating procedure to
be performed or its outline.
Indicates safety information.
Indicates supplementary informa
-
tion.
Indicates reference to some other
document or section.