Mitutoyo EJ-102N - Preset

23
No. 99MBC139A
3 Operation Procedure
3.2.2 Preset
Preset replaces the current value with an arbitrary value (preset value).
Tips
• The factory default preset value is 0.
For details, see "3.2.5 Setting Preset/Tolerance Values" on page 27.
• When making zero settings, do so after setting the preset value to 0.
■Setting preset values
Tips
For details, see "3.2.1 Switching the Display Channel (Ch.)" on page 22.
1
Display the channel for which you wish to set the preset value.
2
Set the peak mode to current value display.
Press the [MODE] (>) key so that the peak
indicator (MIN/MAX) goes out.
Tips
For details, see "3.2.3 Peak Hold" on
page 25.
MODE
Fn
SEL / CE
Ch.
TIR
P.SET
1
3
Press the [P.SET] (^) key.
» The current value is replaced with the preset
value.
» This clears the maximum and minimum values
and the run-out width.
MODE
Fn
SEL / CE
Ch.
TIR
P.SET
1